Any equipment is inseparable from maintenance during use, and the processing process of Fully Automatic CNC Machine is the same. Usually, the maintenance of Fully Automatic CNC Machine processing is very important, including daily inspection, weekly inspection, monthly inspection, quarterly inspection, and half-year inspection. Only careful maintenance can ensure the smooth processing of Fully Automatic CNC Machine.

Fully Automatic CNC Machine order CNC automatic lathe machining repair

1, CNC automatic lathe processing daily inspection. The daily inspection is mainly carried out according to the normal operation of the CNC automatic lathe system. The main maintenance and inspection items include: hydraulic system, spindle lubrication system, guide lubrication system, cooling system, pneumatic system.

2, CNC automatic lathe processing weekly inspection. Weekly check items include CNC automatic lathe parts, spindle lubrication system, etc., and remove iron filings on CNC automatic lathe parts, and will clean up debris.

3, Fully Automatic CNC Machine processing monthly inspection. Mainly check the power supply and air dryer. Under normal conditions, the rated value of the power supply voltage is 180V-220V, and the frequency is 50Hz. If there is an anomaly, it should be measured and adjusted. The air dryer should be disassembled once a month, then cleaned and assembled.

4, CNC automatic lathe processing season inspection. After three months, the inspection and maintenance of CNC automatic lathes were checked around the three aspects of CNC automatic lathes, hydraulic system and spindle lubrication system, including the accuracy of CNC automatic lathes and hydraulic system and lubrication system.

5.Fully Automatic CNC Machine processing half-year inspection. After half a year, the CNC automatic lathe hydraulic system, spindle lubrication system and X axis should be checked, if there is a problem, new oil should be replaced, and then cleaned.

The manufacturer suggests that after being familiar with the maintenance of CNC Automatic lathe processing, let's take a look at the common problems and solutions in CNC automatic lathe processing.

1, CNC automatic lathe processing pressure is not normal, mainly for the pressure is too high or too low, can be opened according to the specified pressure setting cleaning, replace the normal pressure gauge, according to each system check in turn.

2, CNC automatic lathe oil pump injection, there are many reasons, including low oil tank level, oil pump inversion, low speed, high oil viscosity, low oil temperature, filter blockage, vacuum tubing volume is too large, intake, shaft and rotor wear, etc., can only correspond one by one, this is a problem, to be targeted.

Fully Automatic CNC Machine https://www.zjshuangzheng.com/Fully-Automatic-CNC-Machine-Category